Bearing preload springs. This kind of spring is used to remove play between the ball bearings and the bearings' inner and outer races. Preloading reduces the possibility of bearing damage due to vibration and runout. They also reduce the wear and the system noisiness. This type of spring allows radial expansion or an increase of the diameter inside the cavity without sticking or blocking as normally happens with sheared washers. For this reason these springs are more adaptable to the needs. Available in both carbon and stainless steel 17-7 PH-C/CH 900 from 16 mm to 580 mm diameters.

Bearing preload springs. This kind of spring is used to remove play between the ball bearings and the bearings' inner and outer races. Preloading reduces the possibility of bearing damage due to vibration and runout. They also reduce the wear and the system noisiness. This type of spring allows radial expansion or an increase of the diameter inside the cavity without sticking or blocking as normally happens with sheared washers. For this reason these springs are more adaptable to the needs. Available in both carbon and stainless steel 17-7 PH-C/CH 900 from 12,70 mm to 406,40 mm diameters (1/2"- 16" inches).

They are the Nested version of the SSB type preload bearing springs. When the load provided by the SSB springs is not enough, the 2 or 3 turn configurations of these Nested can provide exponentially higher loads. We can therefore now have 3 loads variants with the same radial dimensions.

They are the Nested version of the SSR type preload bearing springs in inches. When the load provided by the SSR springs is not enough, the 2 or 3 turn configurations of these Nested can provide exponentially higher loads. We can therefore now have 3 loads variants with the same radial dimensions.

Wave springs with the same properties of SSR springs with the particular possibility of application in working place highly limited because of their reduced radial width. Available in carbon and stainless steel from 17-7 PH-C/CH 900 from 82,55 mm to 196,85 mm diameters (3 1/4" to 7 3/4" inches).

Wavo Springs are produced from round-section wire to provide higher loads while maintaining the accurate loading found in wave springs. As an alternative to Belleville Springs, the Wavo provides the advantage of an higher accurate and predictable spring rate. Available in both carbon and stainless steel 17-7 PH-C/CH 900 from diameters 12,70 mm to 152,40 mm (1/2" - 6" inches)

Crest-to-Crest springs are typically used in applications requiring low-medium spring rates or large deflections with low-medium forces. They occupy 1/3 to ½ the axial space of a conventional round wire spring while maintaining the same rate and deflection. Standard Parts 6-60 mm diameters Squared-Shim Ends From Stock Carbon and Stainless Steel

Crest-to-Crest springs are typically used in applications requiring low-medium spring rates or large deflections with low-medium forces. They occupy 1/3 to ½ the axial space of a conventional round wire spring while maintaining the same rate and deflection. Standard Parts 8-60 mm diameters Squared-Shim Ends From Stock Carbon and Stainless Steel

Crest-to-Crest springs are typically used in applications requiring low-medium spring rates or large deflections with low-medium forces. They occupy 1/3 to ½ the axial space of a conventional round wire spring while maintaining the same rate and deflection. Standard Parts 6-60 mm diameters Squared-Shim Ends From Stock Carbon and Stainless Steel

Crest-to-Crest springs are typically used in applications requiring low-medium spring rates or large deflections with low-medium forces. They occupy 1/3 to ½ the axial space of a conventional round wire spring while maintaining the same rate and deflection. Standard Parts 8-60 mm diameters Squared-Shim Ends From Stock Carbon and Stainless Steel